BUILDING A FENCING FRAME
WHEELCHAIR FENCING FRAME CONSTRUCTION
TABLE OF CONTENTS
(11) BEGIN WITH 1 ¼ INCH SQUARE TUBING AND CUT FOUR SECTIONS 12 INCHES LONG WITH THE LEADING ENDS HAVING A 45° ANGLE OPENING AND A PRE-DRILLED ½ INCH HOLE 3 INCHES FROM THE FRONT OF THE RECEIVER WITH A ½ INCH NUT, COURSE THREAD, WELDED IN THE SAME LOCATION.
(NOTE:) USE ADDITIONAL ANGLE SLOT TABS WELDED ON LEFT AND RIGHT SIDES OF 1 ¼ INCH RECEIVERS TO FIX TO PLYWOOD. THE TABS ILLUSTRATED HERE ARE 1 X 1 INCH WITH 3/8 INCH ROUND HOLES PRE-CUT IN ANGLE SLOT.
(12) DETERMINE WHICH TWO HOLES MAY PROVIDE THE BEST POINT TO SECURE THE RECEIVER, (PREFERABLY ONE ON EACH SIDE OF THE RECEIVER.) TRACE HOLES AND MARK THE CENTER OF THE HOLES DIRECTLY ONTO THE PLYWOOD. REMOVE RECEIVER AND PREDRILL WITH 7/64TH INCH DRILL BIT FOLLOWED BY 7/16TH INCH PADDLE BIT COMPLETELY THROUGH PLYWOOD. TAMP INTO UNDERSIDE OF PLYWOOD BOARD 7/16TH X 3/8TH INCH T-NUTS.
(NOTE:) THE DISTANCE BETWEEN THE SIDE EDGE OF THE RECEIVER TO THE SIDE EDGE OF THE PLYWOOD IS 2 INCHES. TO ENSURE PROPER ALIGNMENT, PLACE 5 FT X 1 INCH SQUARE TUBING RAIL INTO BOTH RECEIVERS (ONE SIDE OF RAIL SYSTEM) AND LINE UP SIDE EDGE OF TABS 2 INCHES FROM RIGHT SIDE OF PLYWOOD AND MAKE SURE THAT THE FRONT OF THE RECEIVER DOES NOT PROJECT BEYOND THE FRONT SIDE OF EITHER PLATFORM.